[PCB_FORUM] Re: Concept signame question

  • From: Mark Salberg <msalberg@xxxxxxxxxxxx>
  • To: icu-pcb-forum@xxxxxxxxxxxxx
  • Date: Thu, 07 Sep 2006 14:22:19 -0400

Hi Shirley,
Yes, but all it does is point "temporarily" and is very difficult to see if it is to a flag pin, a flag body or a short wire segment.
Then you have to zoom in to see and it goes away. Grantid, you can zoom in and repeat this on every area on every page, but if you miss one...no rat on board.

With all the wiring checks, why not have this? I know...I just couldn't resist.
Thanks for your reply,

Mark


First of all:
Why would it EVER let you add a signal name to a flag if then it would not recognize it as a connection??????????????????????
A new E.E. did not know better and littered the schematic

Bolman, Shirley H wrote:
Have you tried using the show attachment? If a signal name is attached
to a pin there should
be a red line to the pin. Signal names attached to wires show where the
name is attached on the wire.

Shirley in Oregon 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg
Sent: Thursday, September 07, 2006 6:45 AM
To: Cadence User Group
Subject: [PCB_FORUM] Concept signame question

Hello,
Is there a way to tell if signames are attached to a wire instead of a 
flag? Besides attributing each wire which is very time consuming.
We found that a signame can be accidentally assigned to a flag pin 
instead of a wire segment.
Therefore, the connection is not made in the board.

How can we verify this was not done in our schematics.

Thanks,
Mark


________________________________________________________________________
_____
Scanned by IBM Email Security Management Services powered by
MessageLabs. For more information please visit http://www.ers.ibm.com
________________________________________________________________________
_____
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
//www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________

JPEG image

Other related posts:

  1. Home
  2. icu-pcb-forum
  3. Archive
  4. 09-2006