Gerry Thanks for the tip. It's a good day when you learn something new! Alan Ruprecht Staff PCB Designer L3 Communications (Display Systems) 1355 Bluegrass Lakes Pkwy Alpharetta, GA 30004-8458 770-752-5076 Fax:770-752-5495 From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gerry Meier Sent: Wednesday, November 03, 2010 3:14 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Assembly Drawing I use IPF export/Import as well. Tip: When you import change your Class to Drawing Format > Tassy or Bassy (or other created subclasses). You can also use Board Geometry Class. Note: If you do this it will not create Pen subclasses under the Manufacturing Class. Create Detail > at one time had an issue with figures but that may have been corrected, I don't remember the version it was some time ago. Gerry "New Phone Number" Gerry Meier, Sr. PCB Designer Freedom CAD Services. Inc Voice: (256) 715-1424 or (603) 864-1350 Email:gerry.meier@xxxxxxxxxxxxxx Skype: rgmeier3 visit us at http://www.freedomcad.com P Think Green only print as needed. From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of alan.p.ruprecht@xxxxxxxxxx Sent: Wednesday, November 03, 2010 2:01 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Assembly Drawing I have been using IPF due to the fact I get readable/searchable text within my PDF plots I scale to whatever fits the page. Alan Ruprecht Staff PCB Designer L3 Communications (Display Systems) 1355 Bluegrass Lakes Pkwy Alpharetta, GA 30004-8458 770-752-5076 Fax:770-752-5495 From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary Sent: Wednesday, November 03, 2010 1:03 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Assembly Drawing Hey Guys, For those of you that create an Assembly Drawing, do you scale up the outline/assemblies to better fit in the drawing? For years I had used File -> Export -> IPF to create an Intermediate Plot File for both Top and Bottom. I would then use File -> Import -> IPF, then RMB to scale and mirror as necessary. Lately I've been using Manufacture -> Dimension/Draft -> Create Detail. How do you create your Assembly Drawing? Is there another way (better?) that I'm not aware of? Thanks! Regards, Gary MacIndoe Senior PCB Layout Designer Contract - Kelly Services Covidien EbD R&D 5920 Longbow Drive Boulder, CO 80301 303.476.7458 www.covidien.com This correspondence and any attachments are considered confidential. If you are not the intended recipient, please notify Freedom CAD Services, Inc. immediately by either replying to this message or by sending an email to operations@xxxxxxxxxxxxxx; please destroy all copies of this message and any attachments. Thank you.