Should be the same solution as the past versions. Toggle the "stretch etch" off in your options menu. Ann Pelcha CID Tektronix Inc. MBD-Central Engineering PO BOX 500/ms 39-512 Beaverton, OR 97077-0001 Phone: 503-627-3142 Fax: 503-627-5587 (E-mail) - < <mailto:ann.m.pelcha@xxxxxxx> mailto:ann.m.pelcha@xxxxxxx> "Any ideas or opinions expressed here do not necessarily reflect the ideas or opinions of my employer." -----Original Message----- From: Dickoff, Diane J [mailto:diane.j.dickoff@xxxxxxxxx] Sent: Sunday, January 09, 2005 3:04 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] 15.2 dynamic rats I am using 15.2 and when I move a part I am not getting any rats (just a floating part). Once I place it, the rats reappear. I would like to see the rats as I move the part. I believe this has already been discussed in this forum but I can't remember what the answer was. Thanks for any help---- Diane Dickoff Intel Corporation Hillsboro, OR