Ambrish, Excellent. Walter Walter Katz 303.449-2308 Mobile 303.883-2120 wkatz@xxxxxxxxxx www.sisoft.com -----Original Message----- From: ibis-macro-bounce@xxxxxxxxxxxxx [mailto:ibis-macro-bounce@xxxxxxxxxxxxx]On Behalf Of Ambrish Varma Sent: Tuesday, September 28, 2010 5:41 PM To: IBIS-ATM Subject: [ibis-macro] Re: Updated AMI Flow BIRD Fangyi, Thanks for pointing out the double counting in step 6 in section 3.2 during the call. I have added a sentence in step 5b that should fix the issue. Please let me know if it addresses the issue you have raised. Thanks, Ambrish. Ambrish Varma | Member of Consulting Staff P: 978.262.6431 www.cadence.com -----Original Message----- From: ibis-macro-bounce@xxxxxxxxxxxxx [mailto:ibis-macro-bounce@xxxxxxxxxxxxx] On Behalf Of Muranyi, Arpad Sent: Monday, September 27, 2010 10:30 AM To: IBIS-ATM Subject: [ibis-macro] Re: Updated AMI Flow BIRD Hello everyone, In the attached version of the flow BIRD draft I added a few items at the end to remove all mention of Use_Init_Output from the spec, and added Walter's note below to the "Analysis path/data/that led to specification" section. Please review this draft and lets vote tomorrow. Thanks, Arpad =============================================================== ________________________________ From: Walter Katz [mailto:wkatz@xxxxxxxxxx] Sent: Friday, September 24, 2010 1:32 PM To: Muranyi, Arpad; IBIS-ATM Subject: RE: [ibis-macro] Re: Updated AMI Flow BIRD Arpad, I think in the case of Use_Init_Output, we should remove all references to Use_Init_Output in the body of the final 5.1 Version, and add something like the following in a new IBIS Deprecation Section: The parameter Use_Init_Output was an optional reserved parameter in IBIS 5.0. The use of Use_Init_Output has been deprecated in IBIS 5.1, and EDA tools shall ignore the value of Use_Init_Output, and assume that models operate according to the flows as described in IBIS 5.1. In IBIS 5.0, Use_Init_Output only had application to time domain flows in conjunction with dual models (Init_Returns_Impulse=True, and GetWave_Exists=True). Existing dual models that assumed the logic of Use_init_Ouput=True as specified in IBIS 5.0 may not work properly in the flows documented in IBIS 5.1. Walter Walter Katz 303.449-2308 Mobile 303.883-2120 wkatz@xxxxxxxxxx www.sisoft.com --------------------------------------------------------------------- IBIS Macro website : http://www.eda.org/pub/ibis/macromodel_wip/ IBIS Macro reflector: //www.freelists.org/list/ibis-macro To unsubscribe send an email: To: ibis-macro-request@xxxxxxxxxxxxx Subject: unsubscribe