All,
Curtis, as usual the minutes were excellent. I created rev 6 of the BIRD
that addresses the question asked about the case where two [* Reference]
values are 0.0V but their terminals are connected to two different
signal_name on the component.
I also added a section in the definition of the issue that this BIRD only
describes how to measure voltages at a DIA terminal and explicitly does not
deal with comparing these measurements with [Model] thresholds when the DIA
rail voltage measurements (relative to the now clearly defined reference
terminal) are not the same as the rail voltages defined by the [* Reference]
parameters (DUT rail voltage).
This is partially addressed with [Receiver Thresholds], but certainly can be
expanded in an independent scaling measurement BIRD.
Again the intent of this BIRD is a pre-requisite for the Interconnect BIRD
and the Editorial work being done on referencing, GND, and Node 0.
Walter
From: ibis-macro-bounce@xxxxxxxxxxxxx
[mailto:ibis-macro-bounce@xxxxxxxxxxxxx] On Behalf Of Curtis Clark
Sent: Tuesday, July 5, 2016 3:24 PM
To: ibis-macro@xxxxxxxxxxxxx
Subject: [ibis-macro] Minutes from the 28 June ibis-atm meeting
Minutes from the 28 June ibis-atm meeting are attached.
The following document, which was discussed during the meeting, has been
posted to the work archive.
DATE
AUTHOR <http://ibis.org/macromodel_wip/archive-author.html>
ORGANIZATION <http://ibis.org/macromodel_wip/archive-org.html>
TITLE <http://ibis.org/macromodel_wip/archive-title.html>
FORMATS
28-JUN-2016
Walter Katz
SiSoft
Pin Reference BIRD draft 5
(zip
<http://ibis.org/macromodel_wip/archive/20160628/walterkatz/Pin_Reference_BIRD_draft_5.zip>
)(pdf
<http://ibis.org/macromodel_wip/archive/20160628/walterkatz/Pin%20Reference%20BIRD%20draft%205/Pin_Reference_5.pdf>
)
Attachment:
Pin_Reference_6.pdf
Description: Adobe PDF document
