[HFbeacons] Re: Little help with setup

  • From: Stan Stockton <wa5rtg@xxxxxxxxx>
  • To: hfbeacons@xxxxxxxxxxxxx
  • Date: Mon, 18 Sep 2017 18:24:35 -0500

Thanks, Keith, and thanks to all who responded.  Appreciate the advice.

73... Stan

Sent from Stan's IPhone



On Sep 17, 2017, at 10:27 PM, wkhibbert <wkhibbert@xxxxxxxxxxx> wrote:

Stan: If you are running the HTX-100 on Low, you should have no problem with 
the TX even with a major antenna fault. At 25 watts, you can have long-term 
issues even with a perfect match.

On High power, a 50 CFM or bigger fan is advisable due to the PA running at 
about 35% efficiency in Class AB. So, with 25 watts out, you  need to 
dissipate around 50 watts of heat. Running at 5 watts, the ckmbination of the 
PA resting current and low efficiency  will result in around 13 watts of heat 
to dissapate. Even with this, a modest fan is a good idea. With my second 
beacln, I used a 5" power supply fan. 

Between 4 different QTH's, between 1979 and 2005 I ran a beacon on 28.287 
MHz, WB1DNM, KA1YE, KE2DI, KB2YTW & NQ2RP. Heat is your enemy. Keep the heat 
under control and everything else takes care of itself...

73, Keith, WB2VUO, TC-ARRL WNY Section 
Amherst, NY 
 


Sent from my Galaxy Tab® A

-------- Original message --------
From: Stan Stockton <wa5rtg@xxxxxxxxx>
Date: 9/17/17 19:19 (GMT-05:00)
To: hfbeacons@xxxxxxxxxxxxx
Subject: [HFbeacons] Little help with setup

Toward the end of October I plan to set up a ten meter beacon at my QTH on 
Cayman Brac and leave it running.  

My question is:

What is the EASIEST way to protect the rig (HTX-100) if something goes wrong 
with the antenna and the SWR goes high?  Haven't tried to figure out what the 
worst case SWR would be with a dummy load in parallel in the house and the 
coax either open or shorted at the antenna.  I'm not worried about power 
going into a dummy load.  The antenna will be a quarter wave vertical within 
ten feet of the salt water and it will be plenty loud.  Would rather activate 
a coax relay and send all the power to the dummy load if the SWR went high 
but not sure what the least expensive solution is to do that?

Thanks... Stan, K5GO


____________________

The HFbeacons mailing list information: 
//www.freelists.org/webpage/hfbeacons

Other related posts: