Hi All, I have found that in Virtual Mode, when I try to find the total route distance of a created pedestrian or vehicle route by executing r+d+a command, I get senseless reading. It may say "0m total route distance or sometimes 130 metre total route distance. The distance it gives is always the same despite different routes between different starting and destination points. The problem gets resolved when I reset the software to factory default using one of the commands in the option menu. But it comes back again after a couple of route creations in virtual mode. There is no issue when the route is created in GPS mode. There is also no issue when executing other distance commands such as r+a+e to get estimated arrival distance. The other problem I have noticed not just in this version but in previous versions is that it is sometimes impossible to explore straight over a road in virtual mode using CTRL+up arrow when the road has a tunnel or rail track going over or under crossing it even though in real drive or walk, one can go straight forward over the road. I do not know if this particular issue is limited to Australian map. I appreciate comments from someone at Sendero.