Ron, You will have to upgrade at least to version 6.2 (use micro I/A with profibus) or to 6.4 (use CP60 with profibus FBM 223). Did configure some siemens PLC's with micro I/A and FBM223 without any problem. Regards, Patrick Den Haese Invensys Systems Belgium ----- Original Message ----- From: "Murphy, Ronald T" <Ronald.Murphy@xxxxxxxxxxxxxx> To: <foxboro@xxxxxxxxxxxxx> Sent: Friday, 14 February, 2003 20:42 Subject: [foxboro] PROFIbus > > To All, > > Has anyone out there used PROFIBUS to communicate from a Siemens S7-300 = > processor to the Foxboro I/A system with version 4.3 software? > > Thanks in advance, > Ron Murphy > > > > _______________________________________________________________________ > This mailing list is neither sponsored nor endorsed by Invensys Process > Systems (formerly The Foxboro Company). Use the info you obtain here at > your own risks. Read http://www.thecassandraproject.org/disclaimer.html > > foxboro mailing list: //www.freelists.org/list/foxboro > to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join > to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave > _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave