Hi, =20 I had this happen to me a few years ago when I lost a hard drive on t= he AW hosting the CP. =20 After restoring from a tape backup I found that there had been change= s to three CPs since the time of last backup tape. =20 The most minor problem was that a few blocks had been deleted from a compound between the last tape backup and the restore. The blocks were n= ot running in the CP but did show up in the ICC. =20 I was able to delete them from the ICC and all was well. =20 The worst problem was that I had added a few new compounds to another= =20CP. The compounds and their blocks were running in the CP but did not show up= =20in the ICC. =20 I had to initialize the CP (wipe the memory clean) and perform a "loa= dall" from a saveall disk. =20 This meant that the CP had to be off line for about 5 minutes total. Other wise the CP and the running blocks worked just fine. I ran this wa= y for three days until I had the opportunity to take the CP offline. Steve Murray Asarco -----Original Message----- From: Control y Automatizacion (Rodolfo Piedra) [mailto:rpiedra@xxxxxxxxxxx] Sent: Thursday, April 10, 2003 03:24 To: foxboro@xxxxxxxxxxxxx Subject: [foxboro] Control Blocks missing in ICC Configuration We are experiencing a problem in one of our CP where some new blocks are actually running and showed in FoxSelect but they are not present in the = ICC configuration. We can not delete them, because they are running OK, but need to back up properly because we feel they will be lost if we reboot the CP. Any ideas? Thanks in advance, Rodolfo Piedra Control y Automatizaci=F3n SA =20 =20 _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html =20 foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Djoin= to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Dleave= =20 * This e-mail and any files transmitted with it are the property of America= s Mining Corporation and/or its affiliates, are confidential, and are int= ended solely for the use of=20 the individual or entity to whom this e-mail is addressed. If you are not= =20a named recipient or otherwise have reason to believe that you have re= ceived this message in error,=20 please notify the sender and delete this message immediately from your co= mputer. Any other use, retention, dissemination forwarding, printing or c= opying of this e-mail is=20 strictly prohibited. Although this email and any attachments are believe= d to be free of any virus or other defect that might affect any computer = system into which it is=20 received, and opened, it is the responsibility of the recipient to ensure= =20that it is virus free and no responsibility is accepted by Americas Mi= ning Corporation and/or its=20 affiliates for any loss or damage arising in any way from its use This e-mail has been scanned and cleared by MailMarshal=20 www.marshalsoftware.com * _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave