These instructions are perfect. Got the settings updated in five minutes and
communicates perfectly.
Thanks.
Sent from my iPhone
On Jun 6, 2021, at 3:48 PM, Marcelo Fernandes <tchelosoft@xxxxxxxxx> wrote:
Hello Dears:
Initial instructions for the Editor below:
If the FA workstation is properly connected to PC via MIDI, the Editor will
connect to it automatically at start-up and show a positive message
If not, a negative message with instructions will be shown, I will describe
the detailed steps to follow on FA's screen interface
I've create a Accessibility Menu accessed via shortcut key Alt+A. From here,
you can navigate into menus to access all features in the Editor.
The next settings are not available via MIDI. To enable SYNC mode between
Editor and FA workstation the following steps must be done on FA's screen
interface:
Press MENU button
Rotate the SELECTOR DIAL counterclockwise 1 turn to ensure to get the first
menu item
Press RIGHT button, and after ENTER button, to select SYSTEM MENU
Press UP button and hold for 3 seconds to reach the top menu
Rotate the SELECTOR DIAL counterclockwise 1 turn to ensure to get the first
top menu item
Press RIGHT button 9 times to reach the MIDI settings menu
Press DOWN button to reach first item DEVICE ID
Rotate the SELECTOR DIAL counterclockwise 1 turn to ensure to set the value
17 to DEVICE ID
Press DOWN button 4 times to reach item TRANSMIT PROGRAM CHANGE
Press INC button to choose ON for TRANSMIT PROGRAM CHANGE
Press DOWN button to reach next item TRANSMIT BANK SELECT
Press INC button to choose ON for TRANSMIT BANK SELECT
Press DOWN button to reach next item TRANSMIT ACTIVE SENSING
Press DEC button to choose OFF for TRANSMIT ACTIVE SENSING
Press DOWN button to reach next item TRANSMIT EDIT DATA
Press INC button to choose ON for TRANSMIT EDIT DATA
Press DOWN button 4 times to reach item RECEIVE EXCLUSIVE
Press INC button to choose ON for RECEIVE EXCLUSIVE
Press BRASS/WIND/#6 button to perform System Write
Good luck!
Marcelo.