Hi Tamru,
The suggestion of setting your left margin to 3 and your right margin to 43
will work as long as your embosser is not the Pro-60. The Pro-60's right
margin cannot be set higher than 40, which would cause your page to have a
very wide right margin, and only 37 characters per line. To correct the
problem on a Pro-60, you need to physically move the paper as far to the
left as you can. I hope I'm not adding confusion to an already frustrating
problem, but I speak from experience as I have an older Juliet and a Pro-60.
Steve
On Friday 6/27/03 15:58 Braille Computing wrote:
Dear listers,
I am looking for your help urgently in regards to my Juliet Pro Embosser.
When I am embossing, the Braille jumps on the binding whole. I tried the following setting on my embosser:
1. OL OFFLINE THE EMBOSSER: 2. 15.1 for the left margin 3. 14.40 For the right margin
However, still the Braille goes on top of the binding whole.
Can anyone send me instruction how to set the embosser and the dbt for proper outcome?
Thank you in advance for your help.
Tamru.
* * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *
