[duxuser] Re: setting margins

  • From: Elizabeth Slaughter <manutips@xxxxxxxxxxxxxx>
  • To: duxuser@xxxxxxxxxxxxx
  • Date: Sat, 5 Nov 2016 23:04:51 -0500



hi george,

i have the margin problem with most documents i copy and paste from word to duxbury as a duxbury print file, then translate to braille. i always set margins in document rather than embosser, but still, the problem prevails. it is something i am doing with the setting mathematically, i fear, to result in every few lines on the left margin indenting to where the binding space of 2 is, while the other lines are on the edge of the paper.


thanks,

elizabeth



On 11/5/2016 3:16 PM, George Bell wrote:

Hi Elizabeth,

There could be a variety possible issues here.

If this is with an existing document which you have already saved, you ideally should make these 
changes in "Document: Embosser Setup" and not "Global: Embosser Setup".

This is because the embosser settings get saved with the document.

Can I suggest you look at this first?

George

-----Original Message-----
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On ;
Behalf Of Elizabeth Slaughter
Sent: 05 November 2016 19:22
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] setting margins



hi guys,


i am having a problem setting my duxbury braille document margin. i want the 
left binding margin to be set at 3 spaces evenly down the entire page, while my 
right margin falls evenly down the page on the right with perhaps, an inch from 
the edge of the paper. i am using 8.5x11-1/2-inch paper. my embosser is old. a 
blazer, running on windows ten, jaws 17.


my files run too close to the left, leaving too much unused space on the right, 
and some lines indent on the left throughout the document rather than keeping 
the same margin throughout.


any help would be great.

thanks,

elizabeth


* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
*   unsubscribe
* as the subject to duxuser-request@xxxxxxxxxxxxx . You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting www.freelists.org .  The list archive
* is also located there.
* Duxbury Systems' web site is www.duxburysystems.com
* * *
N���,j�����+-v�n��ڵ��zX���+�:.�˛���m��֛����,j���n�˛���m欶����r�hv�n���z�����y�b��(�(�f�j[(���r��z�칻�&�jwlz��q�b�y�u�v�az�.n�+��b�z)�*'����ȭ�x0��y�b��(��zX���܆+ފƥ��hq�^v�^���Ż��,������ע�
0v�[�����^��(m===

* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
*   unsubscribe
* as the subject to duxuser-request@xxxxxxxxxxxxx . You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting www.freelists.org .  The list archive
* is also located there.
* Duxbury Systems' web site is www.duxburysystems.com
* * *

Other related posts: