It's the older one.
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On
Behalf Of George Bell
Sent: Tuesday, October 09, 2018 1:57 PM
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: problem with an ET embosser
Can you please confirm which ET embosser?
Is it actually manufactured by Enabling, or is it the new Juliet, which is
actually an Index Embosser, but with an Enabling badge on it?
George
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On
Behalf Of Jeanne Fike
Sent: 09 October 2018 19:48
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] problem with an ET embosser
Hello everyone,
A friend of mine who has a brailling business and is not on this list has
the ET enabling embosser, similar to the Juliet.
She is having the following issues with it and I was wondering if anyone on
this list might have some suggestions?
Jeanne
Her first message
I was brailling out an order today, and noticed the top of form was nearer
the top edge of the page than I generally like it. It could be read. I
thought
I would be smart and reset the page settings. Now it won't print at all,
just pushes the page up with nothing on it as if it hasn't saved the
settings.
Her second message
yesterday I was doing a book, the main part came out fine except the top
line was too near the top. When i did the cover page, nothing appeared
although
the embosser did its thing as if it were brailling.
Then I did the contents page and the only thing that appeared was three
cells of braille down the left hand side of the upper side of the page,
nothing
else. Then when I turned it over it was the reverse. I then brought up a
document and triedtwo pages and exactly the same thing happened.
