Hi Tamru, I don't have a Juliet manual to hand, but why not use the DBT copy facility? When you do Ctrl + e, the first box in the dialog that comes up is "Copies", and defaults to 1. Change this to the number of copies you want. I would suggest you do not start with 50 if this is a long document. Perhaps a figure which will allow say one or two hours of printing. Embossers do tend to get warm, and so you will be able to give the embosser a short period to cool off between runs. George Bell. -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Braille Computing Sent: 30 June 2003 05:23 To: duxuser@xxxxxxxxxxxxx Dear all, I have a material to be embossed in fifty copies. How do I give an order to my Juliet embosser to do multy copy command so that I don't have to press ctrl e every time until all copies done? please send me the stapes how I could do it! Thanks. Tamru Belay Mr. Point your browser to: http://www3.sympatico.ca/tamru Adaptive Technology Center for the Blind * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * * * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *