[duxuser] Making braille flash cards
- From: "Foxworth, Ann" <Ann.Foxworth@xxxxxxxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Mon, 6 Nov 2006 14:37:11 -0600
I want to make braille flash cards and I'd like to have a line of dots
at the top of the card for orientation. I thought I'd make an entire
sheet with only one letter on it throughout the entire page, having the
orientation line above each line of letters. I can then cut out the
cards. I would rather not use the c or dots 2,5 or 3,6 as they are too
separated from each other. I'd like a line with as few breaks in it as
possible. I will be setting my embosser to jumbo scaling and increasing
the impact to three. I could use the notched corner for orientation but
I think it takes longer to locate that than a tactile line.
Ann Foxworth, Braille Consultant
Criss Cole Rehabilitation Center
4800 N Lamar Blvd.
Austin, TX 78756
PH: (512) 377-0471
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
Other related posts:
- » [duxuser] Making braille flash cards
