Hi all, I'm hoping to track down info, if it exists, for subscribing to a Tiger embosser email listserv. The Viewplus web page wasn't very helpful in determining if a list is even out there. Also, if there is anybody on this list who has knowledge of the Tiger Professional embossers, I'd love to hear your advice on the following problem: I suspect that a gear or some other mechanism has malfunctioned. I loaded the paper into the bottom feeder on the front of the embosser, and successfully embossed one document. I then pressed the load button, which is normally used to pull the paper back into the embosser and set it in the correct position for the next embossing job. When I pressed load, the paper was pulled further in than necessary, almost to the point where it came off the rollers. I then attempted to reposition the paper using the tare button and the manual side roller, but the paper would not move. I removed the paper, and when I again twisted the manual roller, I could feel that the squarish metal bar did not revolve when the roller was turned. This sounds like a mechanical issue, and I want to know whether it is possible to fix this problem remotely. Thanks, Scott