Change the input of the track to use 1 single source as oppose to a stereo source (both channels) an/dor change the track type to mono from stereo... HTH, D!J!X! -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of jim mcauslan Sent: Thursday, October 02, 2008 3:06 AM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] interleave Hi List, After recording and saving my vocal track, when playing back, the vocal is on the left-hand channel. I looked in the inspector pane and found that I had interleave as stereo. As soon as I hit enter on it, the vocal jumps back to both channels. However, it doesn't save this. When I re-open the project, the vocal is still on the left. How can I fix this. All help much appreciated. Jim McAuslan from sunny Findhorn PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq