What you want to do is incert a send to a buss that is carrying the reberv affect. Then you will be able to control the levil of the reverb and the levil of the vocal or guitar. In some cases you don't want much reverb at all, you just want enough to make the vocal or guitar colorful. In other cases you may want your reverb to be a little bit more noticeable. It just depends on your own tastes. After you have incerted your send, you'll want to fine toon the settings of the reverb in the inspector of the buss that is carrying the affect.
I hope this helps you.----- Original Message ----- From: "Laurie Simpson" <simp749@xxxxxxxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx> Sent: Tuesday, February 27, 2007 8:00 AM Subject: [ddots-l] Reverb tips and tricks Hi folks! I'm looking for any advice on the use of reverb. I've tried using various reverb: Cakewalk, Lexicon pantheon, Sony...and, although I get spectacular results with some instruments, other instruments and voices seem muddy. My favorite of all of the reverb I've tried is the Lexicon, but even then, sometimes things aren't as clear as they are without it. Whistles and flutes seem to love lots of reverb but vocals and guitars seem to be more difficult. When we record a song, my husband John will ask if I can make the vocals wetter. When I do, however, it's hard to keep the clarity. What has anyone else tried? Any advice? Any tried and true settings? Thanks! Laurie ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=subscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subjectúq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq
