Hi, I really liked the Project Mix that I had on evaluation. The only drawback that I found (and it was enough for me to not keep it), was the way that the Aux buttons worked - one press of Aux 1 would set up the rotary encoders on the channel strips to do one thing. A second press got them to do something else and so on. Others may not find this to be a problem but I found that I lost track very quickly as to how the encoders were configured. A real shame as, if the firmware were written differently, M-Audio could have achieved the same result without using nested "pages" of setup by using Shift+Aux1, Alt+Aux1, Shift+Alt+Aux1, etc.. The shift and alt keys exist on the unit - I'll be raising this with my M-Audio rep to see if it's possible to get the change into a future release. Cheers. Tim -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Gordon Kent Sent: 18 April 2006 22:24 To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Re: ProjectMix Mike: I worked with Gudrun's project mix i/o last week and my initial impression was that the project i/o software is quite accessible and could be scripted. I certainly didn't explore it in home row or anything like that because I was in the middle of training Gudrun, but I've certainly seen a lot worse. Gord ----- Original Message ----- From: Mike C <mailto:m_dsmusic@xxxxxxxxxxxx> To: ddots-l@xxxxxxxxxxxxxxxx Sent: Tuesday, April 18, 2006 7:18 PM Subject: [ddots-l] ProjectMix Hi guys and gals on list. I know that Lew also has a Project Mix, my question is as follows 1. How were you able to update the Project Mix to the latest Firmware? and 2. In your opinion is the control panel on the porject Mix scriptable? I've been trying to fidle arround with reclassifying the windows, and trying to use the homerow feature to try and find my Window but Jaws reports that the Child window, nor the parrent Window can not be found. I just finished taking the script writing course in St. Peter's Burg, and of course at this time I'm no experct, so that's why I'm seeking advice. Let me know. ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq