or maybe you have not enabled clip looping and you are only setting the tempo to make the loop fit but that will not be precise. try enabling clip looping. ----- Original Message ----- From: "Jay Thompson" <jayken2000@xxxxxxxxx> To: <ddots-l@xxxxxxxxxxxxx> Sent: Tuesday, September 25, 2007 11:21 AM Subject: [ddots-l] Looping > Hello everyone I was wondering somthing about Sonar. > Is there a way I can keep my loops from cutting off at > the end. During the loop it's playing along just as > it should but it seems that whenever it gets to the > point when it rewinds back around, it cuts off a peace > of audio, and starts over. Unlike an mpc where even > at the end the audio finishes its peace and starts > over again. > > Jay Thompson > You can do all things through Christ that strengthens you. Phil4:13 > > > > ____________________________________________________________________________________ > Building a website is a piece of cake. Yahoo! Small Business gives you all > the tools to get online. > http://smallbusiness.yahoo.com/webhosting > ** To leave the list, click on the immediately-following link:- > ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] > ** If this link doesn't work then send a message to: > ** ddots-l-request@xxxxxxxxxxxxx > ** and in the Subject line type > ** unsubscribe > ** For other list commands such as vacation mode, click on the > ** immediately-following link:- > ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] > ** or send a message, to > ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq > ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq