Thank you Kevin! Now I can stop looking. :) Erik -------------------------------------------------- From: "Chris Smart" <csmart8@xxxxxxxxx> Sent: Wednesday, April 20, 2011 8:05 PM To: <ddots-l@xxxxxxxxxxxxx> Subject: [ddots-l] Re: Deleting automation in bus pane?
Thanks for that Kevin. My advice was a little wrong then. Chris At 01:38 PM 4/20/2011, you wrote:Not possible. All you can do is delete all automation for a given region in the project. However, this will remove all automation, even that which you wish to preserve. Your only hope is to undo while the project is being done. Once the project is saved and closed, you're out of luck.KevinPLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxxand in the Subject line type faq
PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq