Going to have to try again with different settings on PF3. I have a suspicion
that I did not setup things correctly because I had similar problems last night
flying from KABQ to KPHX where I ended up much too close to the airport without
any runway to expect to land on.
Jordan
From: bvipilots-bounce@xxxxxxxxxxxxx [mailto:bvipilots-bounce@xxxxxxxxxxxxx] On ;
Behalf Of Robert Cezar
Sent: Tuesday, January 31, 2017 1:18 PM
To: bvipilots@xxxxxxxxxxxxx
Subject: [bvipilots] Re: Just crashed flying into KABQ using PF3
Hi,
I conducted the same flight in a Boeing 738 (I do not have an Embraer 190 on my
development PC) using MS-ATC and the flight was perfectly normal (see attached
CVRT). The ACARS PIREP was also uploaded.
r
On Sun, Jan 29, 2017 at 8:08 PM, Jordan Gallacher
<jordanandseptember@xxxxxxxxx> wrote:
I was flying a Embraer 190 into KABQ, and was going to be landing on runway 3.
PF3 was working pretty well except for telling me to descend to 15,000ft much
too early. IYP was the issue this time around since it switched to ILS
Approach mode too soon and too close to the airport. Thus, I ended up crashing
onto a hill somewhere in the ballpark of 5 miles from the airport.
Jordan