[bookport] Re: how to unsubscribe

  • From: "LARRY SKUTCHAN" <lskutchan@xxxxxxx>
  • To: <bookport@xxxxxxxxxxxxx>
  • Date: Wed, 09 Jun 2004 12:48:16 -0400

Whoops, wrong list!

To unsubscribe from the Book Port list, send a message to bookport-request@=
freelists.org and put the word unsubscribe in the subject line!


>>> clarence@xxxxxxxxxxx Wednesday, June 09, 2004 12:37:10 PM >>>
Larry, didn't you guys make topica go away?  Wouldn't it be to=20
freelists.org now?  <smile>


At 12:32 PM 6/9/2004 -0400, you wrote:

>Just send a blank email to bw-unsubscribe@xxxxxxxxxx=3D20=20
>
>
> >>> smangis@xxxxxxxxxxx Wednesday, June 09, 2004 12:28:35 PM >>>
>                 Since summer vacation is approaching, I would like to
>unsubscribe. Can someone send directions to do this.=3D20
>
>Sue Mangis=3D20
>
>-----Original Message-----
>From: Paul Henrichsen [mailto:paul@xxxxxxxxxxxxxx]=3D20=20
>Sent: Tuesday, June 08, 2004 7:19 PM
>To: bookport@xxxxxxxxxxxxx=3D20=20
>Subject: [bookport] never mind my last question, but a few comments
>
>
>Hi, Larry and Rod. Never mind my last question. Turns out the book I =3D
>was=3D20
>trying to load was not type four.
>I will have to go back and see if I can get it as type four.
>However, some comments.
>It takes an extremely long time to load one of these files, much =
slower=3D20
>than loading an mp3 file.
>Also, I was surprised that in a book that contains more than one file, =
=3D
>I=3D20
>have  to load each part separately.
>And why the combo boxes that ask me where I want to start and end? If =
I=3D20
>have plenty of room, why would I not want to start at the beginning and =
=3D
>end=3D20
>at the end<grin>? I don't understand the use of these boxes.
>Why would I want to start five minutes in or more?
>Thanks.


Clarence Whaley
Training Division Manager
GW Micro
E-Mail:  Clarence@xxxxxxxxxxx=20
Direct Voice (615) 383-6248
or 866-699-8901
Direct Fax (260) 489-2608
GW Micro Voice Number 260-489-3671
http://www.gwmicro.com=20
or press enter below to read all about our training program
http://www.gwmicro.com/training =20




Other related posts: