My general recommendation for such effects like reverb, delay and so
on is to apply them to a duplicate of the original (Control+d).
The Audacity reverb has the check box "wet only" which should be
enabled. 3rd party effects have a similar control, e.g. mix or
Don't forget to deactivate (deselect) the original before going on.
Once the reverb is applied, you can change it's gain or panning or
create fades according to your wishes.
2016-12-02 4:38 GMT+01:00, Matt Turner <meturner2214@xxxxxxxxx>:
In my project, i have a vocal part, that i want the reverb to start out
at a low volume.
Then, I'd like to gradually bring the reverb volume back up again.
Is there anyway to do this?
The audacity4blind web site is at
Subscribe and unsubscribe information, message archives,
Audacity keyboard commands, and more...
To unsubscribe from audacity4blind, send an email to
with subject line