Ea02 error when tracing a path with the Curve tool. What does it indicate? Sequence of events that may lead to error but hard to be precise what causes it to happen. 1. Draw a petal outline (horizontally). Draw a group of closed paths inside approximately following the outline and abutting each other - when finished the effect creates vertical bands inside the petal. 2. Fill each shape with a graduated colour fill. 3. Apply blends between each shape. 4. Set one end of the petal to touch the centre of a 12 segment concentric-grid. 5. Use a sequence of Clone/Rotate/CTRL-drag (angle constraint set to 30 degrees) to create 12 petals. 6. The next procedure is in preparation for ClipView but the error occurs before its use. Use the Curve tool draw another closed path over any petal - a few points will appear but this is where the error occurs. Richard ------------------------------------------------------------ To change, suspend or cancel your subscription go to //www.freelists.org/list/artworks ------------------------------------------------------------