This message was posted by djames on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/366.html#000002 You might go into the maintenance tab, then to the stepper tab. At the bottom there should be Select trimmer type. This should be set at 0. Hit Detect Trimmer, then Set. Go up to the trimmer column and hit the in and out buttons to make sure the knife is moving in and out then you should be good to go. Debbie =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================