Hit the red stop button a few times and it will return to origin before finishing the trace. Aaron Sargent The Linen Barn linen@xxxxxxxxxxx 541-770-2957 Medford, OR ----- Original Message ----- From: <michele@xxxxxxxxxxxxxxxxxxxxx> To: <amayausers@xxxxxxxxxxxxx> Sent: Sunday, April 15, 2007 10:44 AM Subject: [amayausers] cancel a trace command > Is there a way to cancel a trace command? When I'm doing a large design > and > I just need to see that it is in a certain area of a trace, I have to wait > for it to complete the entire trace and then move it again and start the > trace again. Is there a way to cancel it so I can move it more, or start > the design because I see at the beginning that it is where I want it? > > Thanks! > > Michele Zimmer > Carefree Creations > Michele@xxxxxxxxxxxxxxxxxxxxx > www.CarefreeCreations.com > > > > =========================================================== > > The AmayaUsers Mailing List > Website: http://www.amayausers.com > Discussion Board: http://www.amayausers.com/boards > Subscribe/Unsubscribe: http://www.amayausers.com/list > > =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================