This message was posted by GailForce Designs on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/973.html I'm having an issue with the XT WACF Driver Rail. When I install the cap driver as laid out in the manual. I slide the driver rail into the T-Slot as far back as it will go and tighten both thumb screws as tight as I can, yet when embroidering the driver moves forward, pushing the cap and throwing off the registration. The cap is still secure on the cap frame, but the design sews out off register. Any suggestions? Thank you!!! =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================