This message was posted by EEAmayaTech on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1042.html#000001 Hi Pam, There are 2 adjustments that can be made. You can adjust the velcro part up and down or you can adjust the grabber in and out. Velcro part is is At the bottom of the needle case lower left, there is a 3mm screw on the right side of the needle case there are 7mm nuts. You can then move it up and down to help it align with the grabber. Grabber bar in and out is done at the upper left of the needle case. There is a circuit board sitting right above a large black disk. Loosen the 2 screws holding the circuit board and you will be able to slide it front and back, hence setting how far back the grabber bar will go when it is in the velcro. Good Luck, TJ Michigan. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================