This message was posted by signman on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/374.html#000001 Hi Tina... I have a screenprinting setup so I set the jackets on the pallet as though I am going to screen them-and mark off (with chalk) where the design will line up-because the edges of the pallet board are 'square' to each other and I can line the jacket up by seams, hems, whatever. Then I can get exact perpendicular marks for lineup. I slide the inside hoop into the port hole (and YES, sometimes they aren't big enough but you can get it to work) and first the backing if I need it-sprayed with light adhesive on one side. Put that in first, adhesive 'up', use the largest piece you can-and then flatten the jacket back down to it-so it sticks to the back. Slide your hoop in under this and you know it will stay in place. Line the jacket up on the pallet/board again, and you can move the inside hoop around with your fingers from the outside until it is where you want it-put the outter hoop in place and make sure it is lined up again-then push down and hoop it. Takes a little practice but it does work. I find loosening up the screw makes it easier for thick jackets-once it is hooped reach inside and snug the screw up all the way and you are good to go. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================