This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1185.html#000001 If you have a set of bars that are attached to a frame that slides into the dovetail slot on the bottom of the sewing arm and the cylinder is a separate part, then you have the Extended cap driver system. The XT Extended designation should then be used. The WACF was for the pre-extended models that were all one peice. Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================