This message was posted by Ian on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/988.html#000002 With the Auto-feed you will tend to see less bobbin. If you do not see any, especially on columns wider than 2 - 4mm, loosen the bobbin very slightly. Sew a FOX test and look again. You should see some, but not neccesarily 1/3 split. If you notice it coming to the front, you've gone too far. Also note that as your bobbin getts to the end there will be less tension.... grab a fresh one =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================