In lettering properties under baseline choose ccw then change the angle to 180 and apply. Hope this helps Russell Silva R. S. Embroidery Amaya Technician & Trainer Attleboro, Ma 508-222-4433 ----- Original Message ----- From: "Darlene Weber" <image_maker31@xxxxxxxxx> To: "Amaya" <amayausers@xxxxxxxxxxxxx> Sent: Friday, December 08, 2006 6:15 PM Subject: [amayausers] Arc > Can someone tell me how to get a lower arc in DS??? > I have a design that they want the name in arc over the design and the > town arched under the design. They would form a circle kinda. > > I'm sure it is simple, but at this time of the day, simple is very > difficult!!! > > Thanks, > Darlene > > --------------------------------- > Need a quick answer? Get one in minutes from people who know. Ask your > question on Yahoo! Answers. > > =========================================================== > > The AmayaUsers Mailing List > Website: http://www.amayausers.com > Discussion Board: http://www.amayausers.com/boards > Subscribe/Unsubscribe: http://www.amayausers.com/list > > =========================================================== > =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================