This message was posted by Digital Stitchz / LaserWorkz on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/744.html#000001 Am busy and don't want to take time to address first problem. But for the 0: When the appliqued 0 is in design shop, I manually put in a singleline over the center of the 0 where I want it to sew. In design shop, the 0 will have an Outline1 and an outline 2. Usually the 2 is for the center. Just highlight all the points for outline 2 and delete them. You now will have the 0 without the jump stitches from outside to inside. You just have to make your single line the same width and density as your applique. Barbara Ott =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================