This message was posted by gcannon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1253.html#000001 Go in under tools>settings>thread feed. Thge default for col,umn feed is 40 and run/fill feed is 100, auto-lower limit is 1, but I set mine on 2. If these settings are correct, I would suspect that you have a faulty thread-feed motor. What in the world are you doing stitching at four in the morning, BTW? =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================