> Hi All, Here is my design specs modeled after the "portable" ark from Chabad (jpg attached). It has been difficult to get time to work on it and I will be leaving in August for 3 months. > > Elliot > > ------------------------------------------------------------------------ > > Subject: ark design > Date: Sat, 01 Jun 2002 11:59:56 -0400 > From: "Elliot Gaines, Ph.D." <elliot.gaines@xxxxxxxxxx> > Organization: Wright State University > To: Jay Rothman <jrothman@xxxxxxxxxxxxx>, pschreibman@xxxxxxxxxx > References: <B91A3E2F.55E8%jrothman@xxxxxxxxxxxxx> > > Jay and Paul, > Here are the approx specs and an attached jpg of the oversized Chabad > ark. Please share with Rabbi Marianne who has concerns. > I will be in Florida with my mother who is seriously ill, back June 10 > to teach. > > Elliot > > Proposed Portable Ark design: > I suggest cherry, though oak or maple will work as well. Because of > weight concerns, I suggest floating panels made of fine finished veneer > rather than laminated solid wood (stronger and lighter, veneers are well > made, just as attractive and strong at 1/10 the weight). > > INSIDE DIMENSIONS to accomodate two torahs: > 12? deep > 40? high > 32? wide > > Two sides=mortise and tenon (approx) 3? wide solid wood. Inside edges of > the assembled frame are prepared with a routed groove to accept a > floating (3/8? veneer) panel. > Front= mortise and tenon (approx) 3? wide solid wood. Beveled outside > edges to join with sides. > Top, bottom, and back = 3/8? veneer panels (edges covered in assembly). > Two doors mounted on the face of the front mortise and tenon cabinet frame. > Inside light fixture built into recessed top section above the doors, > with wood barrier behind a curtain rod. > Decorative trim molding around top. > > ------------------------------------------------------------------------ > [Image] -- Binary/unsupported file stripped by Ecartis -- -- Type: text/x-vcard -- File: elliot.gaines.vcf -- Desc: Card for Elliot Gaines Ph.D.