Richard, We had a set (Pioneer) a couple of months ago that had a problem with blue convergence on one side and it would not adjust on that side at all----fault was a resistor that had changed value- I believe it was supposed to be a 2.2 ohm and it read about 4.5---if there are low value resistors in that circuit and you've changed the conv IC's and then switched them to check if fault the same, start checking the resistors and any lo value filters. HTH Peter Kowalik pe.kow@xxxxxxxxxxxx Keith's Stereo Burl on -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of Richard Kierski Sent: March 31, 2004 1:21 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] toshiba projo convergence pix has a green bow in from right side of screen going toward center of screen i changed both stk392-110 and several caps on conv module still have same problem. thanks rich ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ --- Incoming mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.614 / Virus Database: 393 - Release Date: 05/03/2004 --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.614 / Virus Database: 393 - Release Date: 05/03/2004 ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/