John, I haven't seen it on a ITC008, but I have on the ITC22/ATC221. You are to adjust that using a cross hatch. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "John Myers" <myers_tv@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, August 15, 2004 6:38 PM Subject: [TechAssist] rca M#27V530T Ch# ITC008FBK - Vertical setup Hi, Saw my first one of these today. My sister is Eectronics manager at the local bowels of Hell . . er. . . Wal-Mart. Se bought this set the other night. Called me this PM, complaining of lines in the pix. I went over, and found lines in the bottom inch of the pix. I entered the service menu, and re-adjusted the height & Lin (paramaters 6 & 7). When I entered Parameter 6, the bottom half of the picture blanked out. It came back when I went to parameter 7. Was this normal? Adjusting # 7 leared up her complaint. The problem appeared to be vertical overscan. John Myers Myers TV Service Since 1984 Alliance, OH ph 330-821-6545 myers_tv@xxxxxxxxxxxxx www.alliancetvrepair.com ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/