I think it was mentioned not to replace the 110's with 150's in anything but Hitachi. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Avery Boyd" <adBoyd@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, November 28, 2005 12:49 PM Subject: [TechAssist] pioneer pro99 model led goes to green and shuts off. > Working on a pioneer pro99 model. In the home I brought the chassis in > resoldered the sweep board. Took it back, the set would take about > 60seconds > to let the green led light up and it look like the convergence was out. > Took > the convergence board to the shop instslled stk392-150 in place of the > stk392-110, couldn't find any thing else bad on the board, took it back to > house, the convergence still bad. Brought the set to the shop. Would > someone > know what the convergence voltages should be and where they come from? > Thanks Avery.Avery Boyd > 4666B S. Mingo > Tulsa OK 74146 > Phone 918-665-2400 > > ----------------------------------------------------------------------------- > This Email List is accessible to the general public through search > engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/