Closest set I find in paper here is for a CT27G30 series models (ch# AMEDP246,252) Micro IC001 is a MN1873234HYJ. 52 pins. VDD pins: 1,43,42 tied together, to 5V buss and filter caps C014(1000mfd),C037(100mfd), on to transistor Q002 emitter. My SMPS here uses an STK730-020 (IC801). Even if this is not the correct micro, a close inspection should indicate that any pin with an electrolytic directly attached is a possible B+ connection. If low ohms is measured there, unsolder and see if the 5V comes up. These Panasonics micros I've found do short from line surges often. You said the voltage from the switcher was .5V. You mean the 5V buss? Hows the +130V source? Others? Phil Bader gordon elder wrote: >Hi > Hi this set came in dead, there is no relay click.The processor is > MN1873265T7G, I would like to find the Vcc pin.The switching voltage from the > power switch is 0.5v. > > >Gordon Elder > >Audio video Technician, > >Lewis Satellite > >Shadowed lawn, > >Brittons Hill, > >Barbados. > > > >--------------------------------- >Do you Yahoo!? > Check out the new Yahoo! Front Page. www.yahoo.com > > >----------------------------------------------------------------------------- >Lost Password: >http://www.tech-assist.org and select "Login Problems?". >Email Archives: >//www.freelists.org/archives/techassist/ > > > -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/