Remote Number Is G96SVC , 4835 219 17656, Adolph Gower Cordova TV 10275 Old Placerville Rd. #5 Sacramento, Ca. 95827 Source for good used parts. Ph. (916) 363-6565 Fax (916) 363-7623 ----- Original Message ----- From: "Philip Bader" <tjanphyl@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, December 21, 2002 5:49 AM Subject: [TechAssist] Re: "fix" update: tuner? philips/ Mag TS2754, 27B800-7562 shuts down, no vert. IC500...] > > I have the "service remote". I don't have the customer remote with the > "smart" button. > The remote I have is the service remote needed for hotel sets.On my > service remote there is no such button. > Phil Bader > > Adolph Gower wrote: > > > > You must have service remote to save your changes. > > Adolph Gower > > Cordova TV > > 10275 Old Placerville Rd. #5 > > Sacramento, Ca. 95827 > > Source for good used parts. > > Ph. (916) 363-6565 > > Fax (916) 363-7623 > > ----- Original Message ----- > > From: "Philip Bader" <tjanphyl@xxxxxxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Friday, December 20, 2002 2:41 PM > > Subject: [TechAssist] Re: "fix" update: tuner? philips/ Mag TS2754, > > 27B800-7562 shuts down, no vert. IC500...] > > > > > > > > Entered service mode, copied down all values I found.i did the "default > > > to factory settings". This restored my tuner operation.The vert height > > > was narrow and v. centering needed adjusting. Did that Trouble is, they > > > say to save that page values press "smart" on the remote. I only have > > > the master remote that has no "smart" button. Is there an equiv. button > > > I can save this with? Seems after I doo all this even pulling power > > > (supposedly this saves data) it comes on with the narrow vert hgt again, > > > unsaved.I re read all the info on the disc.help... > > > Phil Bader > > > > > > Philip Bader wrote: > > > > > > > > see thread below: was shutting down,fixed vert,now no tuner op. > > > > > > > > Unsolderd the eeprom chip IC346, powered the set up, and it now works > > > > OK. Note the vertical is a bit narrow, and probably several other > > > > parameters wrong, as the set is working without an EEPROM, so is working > > > > under "default" settings.At least I know I must reinitialise, or at > > > > worst replace the eeprom.Is it possible, and wise to reinstall the > > > > old,and enter service mode to record the orig. settings for when I wipe > > > > out the chip to start over? > > > > Phil Bader > > > > > > > > Friday, December 20, 2002 11:47 AM > > > > update: tuner? philips/ Mag TS2754, 27B800-7562 shuts > > > > > > down, no vert. IC500... > > > > > > > > > > > > I replaced IC500 (TDA9302H), D409 (483513037094, NTE580) and > > resistor > > > > > > R420 (1 ohm). This restored vertical and stopped shut down. Now, the > > > > > > tuning is off frequency.I select ststions and may hear a bit of the > > > > > > audio but sound and pix if off tune. I do have my +33V, +5 and all > > other > > > > > > voltages to tuner (I have the force disc).SCL and SDA have pulse > > > > > > activity. > > > > > > Of course I suspect tuner, but any history on this chassis for this > > > > > > tuning defect? > > > > > > Phil Bader > > > > > > > > > > > > Philip Bader wrote: > > > > > > > > > > > > > > The usual IC500 solder breaks on pins destroy IC500 (TDA9302H) and > > Vcc > > > > > > > resistor to fly R420. What exactly is R420 value? 1 or 10 ohms?? > > > > > > > Phil Bader > > > > > > > -- > > > > > > > > ------------------------------------------ > > > > Submit A Repair Tip For Everyone Here: > > > > http://www.tech-assist.org/secure/tip/main.html > > > > ------------------------------------------ > > > > To REMOVE your email address, click here: > > > > http://www.tech-assist.org/unsubb.html > > > > To CHANGE your email address, click here: > > > > http://www.techassist.net/forms/change.html > > > > > > -- > > > Philip Bader > > > Jan Phyl TV Inc. (estab. 1976) > > > 3420 Recker Hwy. Winter Haven, Fl. 33880 > > > Fax (863) 299-8821 > > > email: tjanphyl@xxxxxxxxxxxxxxx > > > > > > ------------------------------------------ > > > Submit A Repair Tip For Everyone Here: > > > http://www.tech-assist.org/secure/tip/main.html > > > ------------------------------------------ > > > To REMOVE your email address, click here: > > > http://www.tech-assist.org/unsubb.html > > > To CHANGE your email address, click here: > > > http://www.techassist.net/forms/change.html > > > > > > > > > > ------------------------------------------ > > Submit A Repair Tip For Everyone Here: > > http://www.tech-assist.org/secure/tip/main.html > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.techassist.net/forms/change.html > > -- > Philip Bader > Jan Phyl TV Inc. (estab. 1976) > 3420 Recker Hwy. Winter Haven, Fl. 33880 > Fax (863) 299-8821 > email: tjanphyl@xxxxxxxxxxxxxxx > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html