Charles, is the OSD working ? if it`s there but shifted to one side and distorted check for a leaky C3302 off pin 5 of U3200. If the OSD is a series of blocks instead of normal characters check pin 8 of U3200 for 5 volts if not there re-solder both ends of JW325 whether it looks bad or not. Another common item for both audio and video would be the 9 volt source, if it`s missing you would lose both, (collector source voltage for Q1201 audio buffer, Q2701 video buffer). The only other tip I have on no sound or video is ; leaky CR4101 RCA # 207878. hth Larry Eastman American Tv & Electronics Crystal River, Fl. www.tvjunkyard.com repair1 wrote: >Ctc169 lightbox has hv, filaments, no raster, no audio,collector of q7048 is >0, so I assume it is not in scan loss mode, turning up g2 controls produces >no raster, any help would be greatly appreciated. >charles betzler >Best Electronics >repair1@ix,netcom.com > >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.tech-assist.org/change.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/