Replace the Power supply /Sweep board or at least look at the rectifiers and caps in the power supply. Usually theres a diode on the left edge of power supply board that shorts. Cant' recall location number hth Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Thursday, June 24, 2004 1:32 PM Subject: [TechAssist] Zenith Z52Z95D 9-1690-1 Convergence repeat failure > This set plays for about a week or two with a new 9-1690-1 module then it > fails. I already thought it is probably just Zenith sending me out defective > modules, but I just thought I would ask if there is anything I am missing on > the power supply module or any where else. When it fails it burns R1460 or > R1461 and sometimes burns R4162 or R4163 which means one or the other of the > STK392-110 goes bad. Thanks for any advise on this set. > > P.S. I am sending this message at 12:30 PM MST 6/24/04. Lately all the > messages I send don't show up for a long time so I am going to see when this > one posts. > > Shaun > > Advanced Electronics > 224 West Riverview Ave. > Fort Morgan, CO 80701 > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/