Check for ripple at AC input filter should be near flat line out of filter , no ripple. CTV ELECTRONICS RECYCLE & REPAIR CORDOVA TV 3415 Comet Court Sacramento, Ca. 95827-2924 agower@accessbee,com agower@xxxxxxxxxxxxx Fax (916) 363-8359 Phone (916) 698-6565 Fax (916) 363-8359 Phone (916) 698-6565 agower@xxxxxxxxxxxxxxxxxx (916) 698-6565 ----- Original Message ----- From: "Phil Bader" <tjanphyl@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: 2004Äê10ÔÂ15ÈÕ 14:32 Subject: [TechAssist] Zenith SS1937S/ 9-1119-03r vertical bounce after recapping module : About 6 bad lytics throughout board replaced due to dead set. Cleaned : board. Now worked well while it was on hours test playing. : After setting overnight, powered it on cold,and there's a 60Hz vertical : bounce in the picture. I replaced the caps around the vert IC. What am I : missing? : Phil Bader : : -- : : Philip Bader : Jan Phyl TV Inc. (estab. 1976) : 3420 Recker Hwy. Winter Haven, Fl. 33880 : Fax (863) 299-8821 : email: tjanphyl@xxxxxxxxxxxxxxx : : : : ----------------------------------------------------------------------------- : Lost Password: : http://www.tech-assist.org and select "Login Problems?". : Email Archives: : //www.freelists.org/archives/techassist/ : ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/