Thanks Ron and Ken for your info, Damon Brunger damon101@xxxxxxxxxxxxxx Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: "Ron Miller" <rlmbkm@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, October 06, 2001 9:21 AM Subject: [TechAssist] Re: Zenith PTV, PV5257RK, 9-1194-1 blown > > Look for hi esr on bright blue caps on the 9-1193 mod.I would change ALL the > bright blue caps and also check anode leads for holes. > Ron Miller > D.T.V. Texas > > ----- Original Message ----- > From: <damon101@xxxxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Saturday, October 06, 2001 6:40 AM > Subject: [TechAssist] Re: Zenith PTV, PV5257RK, 9-1194-1 blown > > > > > > > > Damon Brunger > > damon101@xxxxxxxxxxxxxx > > Telrad Electronic Services > > Ft Wayne, IN 46815 > > > > Also note my concern about this unit: The 9-1194 module was replaced > > previously about 9 to 15 months before. Has anybody had a slow death occur > > attributed to the High Voltage Splitter or Crts? Picture on this set was > > clean/sharp. I asked the customer if they heard any > snapping/arcing --Nope, > > was just running and **Blink** went out. Tell me what you've seen and > > Thanks in advance. > > > > ----- Original Message ----- > > From: "Jim Myers" <jr.myers@xxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Friday, October 05, 2001 11:42 AM > > Subject: [TechAssist] Zenith PTV, PV5257RK, 9-1194-1 blown > > > > > > > Zenith PTV, PV5257RK, 9-1194-1 blown > > > > > > Replaced the 9-1194-1 module and set turns on with sound and has B+ to > the > > HO transistor but no horz drive. Is the horz drive generated on this > module > > or does it come from the signal module. TNX for any help > > > > > > Jim Myers > > > jr.myers@xxxxxxxxxxx > > > > > > Help make your TechAssist online repair tips > > > database better! Submit your fixes here: > > > http://www.circuitwork.com/techassist/tip/#tips > > > To unsubscribe write to: > > > techassist-request@xxxxxxxxxxxxx > > > with unsubscribe in the subject line. > > > > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > > > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.