Your convergence is off--due to : somebody was working around the green crt and bumped the static alignment rings (if the green picture is square and undistorted, that is) or if distorted it may be convergence amp BUT and this is a BIG BUT.....the most common failure is the RED/Blue convergence amps have fried one of 4 1 ohm resistors that connect the convergence amps to the + and - B+ supplies. they're located about an inch away from the conv amp out heat sink ----- Original Message ----- From: "Leslie A Jones" <leslie1281@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, November 30, 2001 6:02 PM Subject: [TechAssist] Zenith Big screen help > > The model number is PVR5263. What I am getting > is a double image on the screen, like the > green gun is way off. I cover up the green > tube and everything is ok. I mean the blue > and red fall in line. Uncover the green tube > and it goes back to dual image-like a reflection. What is going on. Any Help > appreciated. > > Leslie A Jones, Jr > ELECTROFIX COMPANY > 1321 Lincoln Street > Portsmouth, VA 23704 > 757-397-7545 > mailto: leslie1281@xxxxxxxxx > -- > > _______________________________________________ > 1 cent a minute calls anywhere in the U.S.! > > http://www.getpennytalk.com/cgi-bin/adforward.cgi?p_key=RG9853KJ&url=http:// www.getpennytalk.com > > > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe