Yep...that was it... B+ was at 145VDC....a new STR53041 solved that! Thanks! Jeff Stielau Shoreline Electronics Repair 125 Beechtree Lane Westbrook,CT 06498 860-399-1861 Voice 860-664-3535 Fax jstielau@xxxxxxxx ----- Original Message ----- From: "Dave Routson" <davestv@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, October 10, 2001 5:17 PM Subject: [TechAssist] Re: Zenith 9-1132 Loses H-drive > > Sounds like you're going into shut down > on any change in set. Have you checked B+ to see if running 123V. > Dave Routson > > > ----- Original Message ----- > From: "Shoreline Electronics" <jstielau@xxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, October 10, 2001 3:37 PM > Subject: [TechAssist] Zenith 9-1132 Loses H-drive > > > > > > Make : Zenith > > Model : SJ2765W5 > > Chassis : 9-1132 > > > > Problem : When changing channels set may lose raster & HV. Base drive > > disappears. Very intermittent & Unpredictable. Audio stays on > > > > What I have found is that if the set is running fine , if I touch a scope > > probe to the Base of the Horiz Output or the Collector of the Horiz > > Output...the base drive shuts off. > > > > We have changed many caps in The C22xx circuitry per other common > failures. > > > > Has anyone had this problem on these Zenith chassis before? > > > > Jeff Stielau > > Shoreline Electronics Repair > > 125 Beechtree Lane > > Westbrook,CT 06498 > > 860-399-1861 Voice > > 860-664-3535 Fax > > jstielau@xxxxxxxx > > > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.