Sounds like you're going into shut down on any change in set. Have you checked B+ to see if running 123V. Dave Routson ----- Original Message ----- From: "Shoreline Electronics" <jstielau@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, October 10, 2001 3:37 PM Subject: [TechAssist] Zenith 9-1132 Loses H-drive > > Make : Zenith > Model : SJ2765W5 > Chassis : 9-1132 > > Problem : When changing channels set may lose raster & HV. Base drive > disappears. Very intermittent & Unpredictable. Audio stays on > > What I have found is that if the set is running fine , if I touch a scope > probe to the Base of the Horiz Output or the Collector of the Horiz > Output...the base drive shuts off. > > We have changed many caps in The C22xx circuitry per other common failures. > > Has anyone had this problem on these Zenith chassis before? > > Jeff Stielau > Shoreline Electronics Repair > 125 Beechtree Lane > Westbrook,CT 06498 > 860-399-1861 Voice > 860-664-3535 Fax > jstielau@xxxxxxxx > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.