If the colour isn't too bad sometimes you can correct with stickon magnets on the CRT and reset purity. Al G Damon wrote: > > Uh, that's either your yoke is misaligned but most likely the shadow mask is > bad, which means a new CRT. Did the customer get into the set? Or maybe > another shop did (unlikely)? Is the yoke seated up against the wedges, and > any of the paint marks on the neck of the yoke misaligned?? If so, somebody > has been in there before you. > > Damon Brunger > Telrad Electronic Services > Ft Wayne, IN 46815 > > ----- Original Message ----- > From: <Taylorelectronic@xxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, March 02, 2004 1:43 PM > Subject: [TechAssist] Tube deqaussing general question > > > Have 32" JVC set in shop with bad colour distortion. > > Checked dequassing cct and no fault found. > > Customer must have had speakers in close proximity. > > External deqaussing does not resolve problem. > > Does anyone have another method to try?? > > > > Thanks in advance > > > > Taylor's Electronics > > Tom Taylor > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/