Repaired this for shorted Q404(2SD1428)and blown fuse. Replaced C416(10uf/100v)(high esr), transistor & fuse. Resoldered flyback, screen/focus ground, horz dvr transformer & dvr transistor Q402. Sent home. 2 weeks later, customer called that set went dead, click only. Q404 and fuse blew again. Again, replaced Q404. Played OK, but noticed an intermittent arcing interference in the picture. The interference only lasts for a few minutes, then clears out. No noise or hissing from the fly or the yoke, when the interference is present. Q404 and Flyback both run warm, but NOT hot, even after several hours running time. I suspect the intermittent interference may be the cause of the Q404 failure, but the set is running OK now. Anyone got any ideas? Would really appreciate some input! Paul W C&W Electronics Azle Texas _________________________________________________________________ Join the world?s largest e-mail service with MSN Hotmail. http://www.hotmail.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/